Brother Fuser Malfunction Error Reset

Assuming the fuser is OK it can sometimes be reset as follows:

Make sure the printer has been left long enough for the fuser to cool (15mins or so).

Turn on the power, holding the button until the “drum” light is glowing.

Wait a moment, then press the button again and the printer should start a self diagnosis and print the results of the test.

Easyink Support has written 90 articles

If you found this information useful, or have a question or suggestion, please comment below...

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>