If you have an old Kyocera Ecosys FS1000, FS1000+, FS1010 or FS1010+ that does not print in the right position on the page, you could have sticky registration or feed solenoids. This is an easy -ish fix that requires a small amount of tech skill and a number 2 Phillips screw driver. First check the…
Hi If you have a Kyocera Ecosys FS1000, Ecosys FS-1000+, Ecosys FS1010 or Ecosys FS-1010+ laser print that has dirty prints like the sample shown below you have a worn/old drum cleaning blade. To fix this fault you will need to replace the blade with a new one. You may also note that the printing…
This Kyocera FS1020 printer was brought to me because it wasn’t working but the primary fault turned out to be a paper jam. However the printer had some other problems: Light Print – Caused by dirty laser assembly. (The fix is covered in a separate article Kyocera FS-1020 Light or Faded Print – How To Clean A…
This Kyocera FS1020 printer was brought to me because it wasn’t working but the primary fault turned out to be a paper jam. However the printer had some other problems: Light print – Caused by a dirty laser assembly. Dark vertical lines – caused by a dirty charge unit corona wire. (The fix is covered in…